Download USBCNC manual

Transcript
EDINGCNC
Manual
Parameter number
5398
5399
5401
5501
5601
5701
–
–
–
–
5499
5599
5699
5799
Meaning
always runs until the given end point which may
give incorrect tool measurement results.
Always take care that the tool table contains
(approx.) correct tool data
Return value for dlgmsg (+1 OK, -1 Cancel)
Return value for M55, M56
Tool z offset (Length) Tool 1 – Tool 99
Tool diameter Tool 1 – Tool 99
Tool x offset (for Turning) Tool 1 – Tool 99
Tool orientation (for Turning) Tool 1 – Tool 99
(Currently supported only Tool 0 .. Tool 99)
Tool data
Tool ID
zOffset
(Length)
xOffset (For
turning)
Diameter
1
2
..
99
orientation
1-9
1-9
..
1-9
3.1.2.1 TOOL ORIENTATION FOR LATHES
When the G18 plane (X-Z) is selected, special LATHE tool radius compensation can be
used (G41, G42). Depending on the tool orientation and tool radius an extra offset is
applied.
The blue crosses show the radius center of the tool.
12 September 2014
Release 4.01
100