Download C3 CMTS User Documentation
Transcript
10 Command Line Interface Reference
cable downstream annex
Syntax
cable downstream annex {a | b}
Sets the annex type for the downstream. This command has been superseded
by the cable downstream mac-mode command, and is now used only to
set the annex type when the MAC mode is set to wireless.
Since the annex type alone is not sufficient to describe the actual mode of
operation, this command behaves as follows:
Setting Annex A or B mode during startup after a firmware upgrade configures
the system in EuroDOCSIS or DOCSIS mode.
Setting Annex A or B after startup changes only the annex type on the downstream.
See also: cable mac-mode, page 10-198, cable downstream mac-mode,
page 10-222.
cable downstream channel-width
Syntax
cable downstream channel-width {6mhz | 8mhz}
Sets the downstream channel width. Use 6Mhz for North America and Japan,
8Mhz for Europe.
10-220
ARRIS PROPRIETARY — All Rights Reserved
11/14/05
Related documents
Cadant C3 CMTS
User Manual of the ARRIS HDMI to AV Cable (including Shutter)
Cisco Systems 4012460 Specification Sheet
Product Flyer
IS-IS Configuration
R&S®CLGD DOCSIS Cable Load Generator
USB WiMAX modem
User`s Manual - Sierra Video
User Manual
User Manual
ML9636GDZ45A User`s Manual
User Guide - Ubee Interactive