Download Intel Server System SR2625UR

Transcript
Peripheral and Hard Drive Subsystem
6.4
Intel® Server System SR2625UR TPS
Midplane Options
The midplane is the interconnection between the server board and both the hot-swap backplane
and control panel. It is also used to determine which hard drive technology is to be supported.
Two different midplane options are available for this platform: 1) a passive midplane capable of
supporting SATA ports from the server board or SAS using ports from an add-in card; 2) an
active SAS/SAS RAID midplane that contains an on-board SAS controller and requires no
cabling.
This section describes the hard drive interface support of each of the midplane boards.
6.4.1
Passive Midplane
The passive midplane is used as an interconnect, routing drive control signals from either the
on-board SATA ports of the server board or SAS/SATA ports from an add-in card to the hotswap backplane. The hard drive controller signals are cabled to the midplane, which then routes
the signals to the hot-swap backplane through two edge connectors that plug directly into it.
C
B
D
A
E
F
G
H
I
J
AF000047
A.
Power Connector
F.
Fan 4 Connector
B.
Fan 6 Connector
G.
Fan 3 Connector
C.
Fan 5 Connector
H.
Fan 1 Connector
D.
SAS/SATA Connectors
I.
Fan 2 Connector
E.
Bridge Board Connector
J.
Backplane Connector
Figure 32. Passive Midplane Board
58
Enterprise Platforms and Services Division
Intel order number E46130-005