Download CLI Command Reference Manual M5300, M6100, and M7100
Transcript
M5300, M6100, and M7100 Series ProSAFE Managed Switches Note: The no form of this command is not supported, since the rules within a MAC ACL cannot be deleted individually. Rather, the entire MAC ACL must be deleted and respecified. Note: An implicit deny all MAC rule always terminates the access list. The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from 0x0600-0xFFFF. The currently supported ethertypekey values are: appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, and rarp. Each of these translates into its equivalent Ethertype value(s). Table 15. Ethertype keyword and 4-digit hexadecimal value Ethertype Keyword Corresponding Value appletalk 0x809B arp 0x0806 ibmsna 0x80D5 ipv4 0x0800 ipv6 0x86DD ipx 0x8037 mplsmcast 0x8848 mplsucast 0x8847 netbios 0x8191 novell 0x8137, 0x8138 pppoe 0x8863, 0x8864 rarp 0x8035 The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields, respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or outer) tag. The time-range parameter allows imposing time limitation on the MAC ACL rule as defined by the parameter time-range-name. If a time range with the specified name does not exist and the MAC ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with specified name exists and the MAC ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied when the time-range with specified name becomes active. The ACL rule is removed when the time-range with specified name becomes inactive. For information about configuring time ranges, see Time Range Commands for Time-Based ACLs on page 1094. Quality of Service Commands 1069
Related documents
Manual de Usuario NORTEL M7100 Español
ProSafe Managed Switch
ProSafe Managed Switch Command Line Interface (CLI) User Manual
Panamax MAX 5300-PM User's Manual
ProSafe Managed Switch Command Line Interface (CLI) User Manual
HP Moonshot-180G Command Reference Guide
Manual English
ProSafe Managed Switch Command Line Interface (CLI) User Manual
User Manual - FTP Directory Listing
User Manual for the NETGEAR 7300S Series Layer 3
C-DOT/TENDER/2013 - C-DOT Centre for Development of Telematics
Basic Configuration: Rail Switch Power Enhanced (HiOS