1
Download CLI Command Reference Manual M5300, M6100, and M7100
Transcript
M5300, M6100, and M7100 Series ProSAFE Managed Switches
debug vpc peer-link control-message ckpt
This command enables debug traces for checkpointing control messages that are exchanged
between MLAG devices on the peer link. For errors, only the errors in the communication are
traced. For messages, the control message contents that are exchanged can be traced. Both
transmitted and received control messages contents can be traced.
Format
debug vpc peer-link control-message ckpt {error | msg [receive | transmit]}
Mode
User EXEC
debug vpc peer detection
This command enables debug traces for the dual control plane detection protocol. Traces are
seen when the DCPDP transmits or receives detection packets to or from the peer VPC
switch.
Note: To display the debug trace, enable the debug console command.
Format
debug vpc peer detection
Mode
User EXEC
Port Mirroring Commands
Port mirroring, which is also known as port monitoring, selects network traffic that you can
analyze with a network analyzer, such as a SwitchProbe device or other Remote Monitoring
(RMON) probe.
monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). Use the source interface unit/slot/port parameter to specify the
interface to monitor. Use rx to monitor only ingress packets or use tx to monitor only egress
packets. If you do not specify an rx or tx option, the destination port monitors both ingress
and egress packets.
A VLAN can be configured as the source to a session (all member ports of that VLAN are
monitored). Remote port mirroring is configured by adding the RSPAN VLAN ID. At the
source switch, the destination is configured as the RSPAN VLAN and at the destination
switch, the source is configured as the RSPAN VLAN.
Note: The source and destination cannot be configured as remote on the
same device.
The reflector-port is configured at the source switch. The reflector-port forwards the mirrored
traffic towards the destination switch.
Switching Commands
509
