1
Download CLI Command Reference Manual M5300, M6100, and M7100
Transcript
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Parameter
Description
default
Defines the SSM range access list FF3x::/32.
no ipv6 pim ssm
Use this command to remove the Source Specific Multicast (SSM) range of IP multicast
addresses on the router.
Format
no ipv6 pim ssm {default | group-address group-mask}
Mode
Global Config
show ipv6 pim
This command displays the system-wide information for PIM-DM or PIM-SM.
Format
show ipv6 pim
Modes
Privileged EXEC
User EXEC
Note: If the PIM mode is PIM-DM (dense), some of the fields in the following
table do not display in the command output because they are
applicable only to PIM-SM.
Term
Definition
PIM Mode
Indicates whether the PIM mode is dense (PIM-DM) or sparse (PIM-SM)
Interface
unit/slot/port
Interface Mode
Indicates whether PIM is enabled or disabled on this interface.
Operational Status
The current state of PIM on this interface: Operational or Non-Operational.
Command example:
The following example displays PIM Mode - Dense:
(NETGEAR) #show ipv6 pim
PIM Mode Dense
Interface
--------1/0/1
1/0/3
Interface-Mode
-------------Enabled
Disabled
Operational-Status
-----------------Operational
Non-Operational
IPv6 Multicast Commands
1164
