1
Download CLI Command Reference Manual M5300, M6100, and M7100
Transcript
M5300, M6100, and M7100 Series ProSAFE Managed Switches Command example: The following example shows the SDM template when the user sets the next active SDM template: (NETGEAR Switch) # configure (NETGEAR Switch) (Config)#sdm prefer ipv4-routing data-center default Changes to the running SDM preferences have been stored, but cannot take effect until the next reload. Use 'show sdm prefer' to see what SDM preference is currently active. (NETGEAR Switch) (Config)#ex (NETGEAR Switch) #show sdm prefer The current template is the Dual IPv4 and IPv6 template. ARP Entries.................................... IPv4 Unicast Routes............................ IPv6 NDP Entries............................... IPv6 Unicast Routes............................ ECMP Next Hops................................. IPv4 Multicast Routes.......................... IPv6 Multicast Routes.......................... 6144 8160 2560 4096 4 1536 512 On the next reload, the template will be the IPv4 Data Center template. Command example: The following example lists the scaling parameters for the data center template: (NETGEAR Switch) #show sdm prefer ipv4-routing data-center default ARP Entries.................................... IPv4 Unicast Routes............................ IPv6 NDP Entries............................... IPv6 Unicast Routes............................ ECMP Next Hops................................. IPv4 Multicast Routes.......................... IPv6 Multicast Routes.......................... 6144 8160 0 0 16 2048 0 Utility Commands 321
