Download PDF - QuickSilver Controls, Inc.

Transcript
Misc. Commands
Target To Position (TTP)
Description:
This command copies the current Position value into the Target register. This is useful for
removing errors when an obstruction is encountered without losing track of position. This
allows the next motion to move and ramp as expected rather than having to unwind the
accumulated error. This is useful for homing against a hard stop where error is intentionally
introduced, and for removing error before enabling the motor drivers after they have been
disabled.
The Target value is updated by the Trajectory Generator, the Step & Direction mode or one
of the Input Modes. The SilverMax servo loop uses the Target value as the input position
parameter. If the motor is unable to achieve the Target position windup will occur. This
command removes the windup error.
Command Info:
Command
Name
Command
Type/Num
Parameters
Param
Type
Parameter
Range
Set Target To
Position
(TTP)
Program
Class D
146 (0x92)
1 word
NONE
NONE
NONE
Example:
QuickControl Example:
Sets the Target to the current
position.
@16 146 (CR)
SilverMax Response:
ACK only
SilverMax Command Reference
171
Revision 4.01