Download PDF - QuickSilver Controls, Inc.
Transcript
Misc. Commands Target To Position (TTP) Description: This command copies the current Position value into the Target register. This is useful for removing errors when an obstruction is encountered without losing track of position. This allows the next motion to move and ramp as expected rather than having to unwind the accumulated error. This is useful for homing against a hard stop where error is intentionally introduced, and for removing error before enabling the motor drivers after they have been disabled. The Target value is updated by the Trajectory Generator, the Step & Direction mode or one of the Input Modes. The SilverMax servo loop uses the Target value as the input position parameter. If the motor is unable to achieve the Target position windup will occur. This command removes the windup error. Command Info: Command Name Command Type/Num Parameters Param Type Parameter Range Set Target To Position (TTP) Program Class D 146 (0x92) 1 word NONE NONE NONE Example: QuickControl Example: Sets the Target to the current position. @16 146 (CR) SilverMax Response: ACK only SilverMax Command Reference 171 Revision 4.01