Download User`s Manual

Transcript
CHAPTER 9 REMOTE COMMUNICATION CONTROL
[Figure 9.2.3] GMWIN Remote Connection step 1
(3) Network type
According to step 1 connection network, select GLOFA Fnet/Rnet, Mnet, Enet, Fdnet,
Cnet, FEnet, or FDEnet. In [Figure 9.2.3], select GLOFA FEnet as step 1 connection is
done by FEnet.
(4) Base Number
This designates the base no. where the FEnet I/F module is installed for Remote
Connection.
(5) IP address
This designates the IP address of the FEnet I/F module that is installed in the opposite
9-4