Download User`s Manual

CHAPTER 10 DEDICATED COMMUNICATION
Flag in the case where a warm restart is performed when power re-input
after the program is shutdown in the middle of running due to the power
shutdown while performing the program, the operation restarts the
program from the beginning which may cause the error in operation of the
preserved data area. This is available in the initialization program.
Automatic resetting after completion of initialization program. Also
indicates the error when program is shutdown in the middle of running by
'ESTOP' function.
BIT 3
Abnormal operation
shutdown
(ABNORMAL
SHUTDOWN)
[_AB_SD_ER]
BIT 4
TASK crash
Flag indicating a task crash in the case that a repeated execution of the
(regular period, external
same task is required while performing the user program.
task)
(refer to _TC_BMAP[n],_TC_CNT[n])
[_TASK_ERR]
BIT 5
Battery error
[_BAT_ERR]
BIT 6
Light failure detection of Representative flag indicating an error when detecting the light failure of
the external device
the external device by the user program. The error is recovered in
[_ANNUN_WR]
_ANC_WB[n].
BIT 7
-
BIT 8
High speed link
parameter 1 error
[_HSPMT1_ER]
BIT 9
High speed link
parameter 2 error
[_HSPMT2_ER]
BIT 10
High speed link
parameter 3 error
[_HSPMT3_ER]
BIT 11
High speed link
parameter 4 error
[_HSPMT4_ER]
BIT 12
~ BIT 15
-
Flag indicating an error when the battery voltage is less than the
specification for the backup of the user program and data memory.
Reserved area
Representative flag indicating an error when it is not possible to perform a
high speed link after checking each high speed link parameter error.
Reset when the high speed link is disabled.
Reserved area
10-29