Download User`s Manual
Transcript
CHAPTER 7 GMWIN FUNCTION BLOCK LD IL LD ST CAL 1 CON E_CONN CON_ACT EN:= CON NET_NO:= 0 IP_ADDR: ‘165.244.149.190’ SD_PORT: 5000 METHOD:= GLOFA_TCPACT’ CH_NO:= 1 If the ‘CON’ contact turns ‘ON’ as Function Block condition, it demands connection with the number ’1’ channel among the 16 channels of the local station and the port number 5000 of the destination station. In this case, it is performed through the TCPACT method (METHOD) which sends the data from the destination station to the local station on the demond. If the destination station responds to the connection demand of the local station, the connection is completed between the two stations. In this case, it shows the results through the ‘CH_EN’ output. The user can use this bit to communicate, using ‘TCP_SEND’, ’TCP_RCV’, ’UDP_SEND’, ’UDP_RCV’ Enable Condition. 7-9