Download Manual - Festo

2. Fitting
ª
«
©
¬
«
©
©
ª
«
Direction for unlocking
Locks automatically
Safety catch
¬
­
®
­ ®
Front plate of module
Terminal strip
Guide rail
Fig. 2/1: Fitting the modules
Removing
modules
When removing a module, proceed as follows:
1. Switch off the operating voltage and the compressed
air supply.
2. Disconnect and remove the cable on the front of the
module.
3. Unlock both safety catches (see Fig. 2/1) and carefully remove the module.
4. If necessary, seal unused slots with blanking plates.
2-6
SPC200-COM-IBS 0503a