Download E 1x00 - Users Manua..

User Manual
Advanced Operation
Table 4-6:
PARAMETER
LSD-TimeOut
(Cont’d)
Encoder Specific features Configuration Parameters
DESCRIPTION AND VALID OPTIONS
Important:
1. This mode requires that the IRD will be set to:
DATA2-LSD PID filtering=TRANSPORT PAYLOAD
2. The Encoder sets an additional bandwidth to the LS data allocated
bandwidth. (reducing the BW allocated for video). This additional
BW is calculated as [150/TimeOut( )TimeOut expressed at 0.01
Sec units, Additional BW expressed at Kbits/second].
CAUTION:
Be careful when setting this item to a low value (the additional BW is
50Kbit/sec at LSD-TimeOut=3).
LSD-EOF-Char
Activates the EOF mode of the LS data port. If the value is higher
than 255, this mode is disabled. Any value lowers than 255 enables
this mode.
The value is the decimal ASCII value of the EOF character.
Valid Options: 0 thru 255
Example: to specify Control-D, use the value 4
This mode flushes out any pending data if the EOF character is
detected at the input stream.
Important:
1. This mode requires that the IRD will be set to:
DATA2-LSD PID filtering=TRANSPORT PAYLOAD
2. The Encoder sets an additional bandwidth to the data with a
default value of 100 mSec (reducing the BW allocated for video).
This additional BW is calculated as [150/TimeOut( )TimeOut
expressed at 0.01 Sec units, additional BW expressed at
Kbits/second].
3. If the LSD-Timeout is not 0, it is taken as the timeout for extra BW
calculations.
PPCR_interval
Determines the PCR interval in mSec.
Valid Range: 2 - 100
Page 4-54
(Rev 1.0 / March 2004)