1
Download Vectorbeam Series
Transcript
0x400f0050 0x400f0051 0x400f0052 0x400f0053 0x400f0054 0x400f0055 0x400f0056 0x400f0057 0x400f0058 0x400f0059 27.6.8. EO error messages 27.6.8.1. Ethernet Errors Page 298 Could not access the barcode reader link Could not open serial link to barcode reader Could not close serial link to barcode reader Could not allocate memory for barcode reader command Error reading from barcode reader serial link Barcode reader link timeout Incorrectly formatted reply received Barcode symbology not supported Barcode reader rejected command Could not read barcode All of these are internal so the advice is: 1. Check ethernet cabling, transceivers, bridges etc. 2. Reboot subsystem 0x40010001 0x40010002 0x40010003 0x40010004 0x40010005 0x40010006 0x40010007 0x40010008 0x40010009 0x4001000a 0x4001000b 0x1001000C 0x4001000D 0x4001000E 0x4001000F 0x40010010 27.6.8.2. Couldn't spawn Ethernet output process Couldn't create Ethernet input queue Couldn't create Ethernet output queue Couldn't set up Ethernet packet intercept Long Ethernet message send failure Couldn't queue Ethernet message for output Couldn't pass message to Ethernet output Ethernet ifunit failure Host is not connected Missing ethernet packet during block transfer Already connected to a different host Already connected to the subsystem No action Couldn't queue Ethernet message for input Command rejected - qEtherIP queue would overflow Ordinary Ethernet command received by a slave Command Interpreter process suspended On-axis & Standalone EHT errors 0x400b0001 0x400b0002 0x400b0003 0x400b0104 0x400b0141 0x400b0301 0x400b0302 0x400b0401 0x400b0402 0x400b0411 0x400b0412 0x400b0500 0x400b0501 0x400b0502 0x400b0503 0x400b0504 0x400b0505 0x400b0506 0x400beeee 0x400c0101 0x400c0102 0x400c0103 0x400e0001 0x400e0002 0x400e0003 0x400e0004 0x400e0005 0x30AA0001 0x30AA0002 0x40AA0003 Part Number:878275 Couldn't create qErrors queue Couldn't create message queue Couldn't send to message queue Couldn't spawn a task Couldn't spawn Emma command interpreter task Error creating semaphore Error getting semaphore Error allocating memory Error freeing memory Couldn't allocate memory for Emma reply packet Couldn't free memory for Emma reply packet This register is write only This register is read only This register does not exist Wrong data type for this register Data out of range Illegal function attempted Illegal data type Task suspended because of exception CI cmnd receive from qEtherIP queue failed Error in Emma command interpreter Receive from qErrors queue failed Error in DMA write Requested VME DMA xfer over 256-byte boundary Can't set up mailboxes DMA xfer not on 4-byte boundary Can't understand vxWorks version number CCU: Error in digital readback CCU: Error in analogue readback CCU: Miscellaneous hardware fault Vectorbeam Operator Manual
