Download Facility Commander Administration Guide - Sec-Tron

Transcript
Chapter 13. Configuring Intrusion
Devices
This chapter describes how to configure intrusion panels, intrusion areas,
and intrusion inputs. Instructions to connect the RS-232 cable are
included, as well as the parameters to configure the device server.
Readers should know how the current intrusion panel is configured. The
Facility Commander configuration should reflect the intrusion panel’s
internal configuration.
In this chapter:
Overview on page 246
Connecting Intrusion Panels on page 247
Configuring Intrusion Panels on page 250
Configure Intrusion Areas on page 257
Configuring DGPs on page 262
Configure Intrusion Input on page 266
Configure Intrusion Outputs on page 271
Configure Intrusion Keypads on page 275
Facility Commander Administration Guide 2.1
Page 245