Download CH? (Query Only)

Commands Listed in Alphabetical Order
Examples
WFMINPRE? might return the waveform formatting as :WFMINPRE:BYT_NR
1;BIT_NR 8;ENCDG BINARY;BN_FMT RI;BYT_OR MSB;NR_PT
10000;PT_FMT Y;XUNIT "s";XINCR 4.0000E-9;XZERO 0.0E+0;PT_OFF
0;YUNIT "V";YMULT 4.0000E-3;YOFF 0.0E+0;YZERO 0.0E+0;DOMAIN
TIME;WFMTYPE ANALOG;CENTERFREQUENCY 0.0E+0;SPAN
0.0E+0;REFLEVEL 0.0E+0
WFMInpre:BIT_Nr
This command specifies the number of bits per data point in the waveform data to
be sent to the oscilloscope using the CURVe command. Changing this value also
changes the value of WFMInpre:BYT_Nr.
(See page 2-78, Waveform Transfer Command Group.)
NOTE. The WFMInpre:BYT_Nr and WFMInpre:BIT_Nr settings are directly
related; setting one causes the other to be set accordingly. For example,
WFMInpre:BYT_Nr 2 causes WFMInpre_BIT_Nr to be set to 16 (2 * 8 bits/byte).
Similarly, setting WFMInpre:BIT_Nr to 16 causes WFMInpre:BYT_Nr to be
set to 2.
Group
Waveform Transfer
Syntax
WFMInpre:BIT_Nr <NR1>
WFMInpre:BIT_Nr?
Related Commands
Arguments
Examples
WFMInpre:BYT_Nr
<NR1> number of bits per data point can be 8 or 16.
WFMINPRE:BIT_NR 16 sets the number of bits per waveform point to 16, for
incoming data.
WFMINPRE:BIT_NR? might return :WFMINPRE:BIT_NR 8 indicating that
incoming waveform data uses 8 bits per waveform point.
WFMInpre:BN_Fmt
This command specifies the format of the data for outgoing waveforms when
WFMInpre:ENCdg is set to BINary. The format can either be RI (signed integer)
or RP (positive integer).
(See page 2-78, Waveform Transfer Command Group.)
2-580
MSO3000 and DPO3000 Series Programmer Manual