Download HP E5100A,B Service

NOP = 2
IF BW = 10 Hz
Power = 0 dBm
Input-A Attenuator: 25 dB
4Sweep5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NUMBER of POINTs
NNNNNNNNNNNNNNNNN
IF BW
4105
NNNNNNNNNNNNNNNNN
POWER
4System5
405
21
21
NNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNN
425
2
NNNNNNNNNNNN
1
RETURN
NNNNNNNNNNNN
NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNN
MORE ATTENUATOR PORT : A
25 dB
4. Set the step Attenuator setting to 0 dB.
5. Perform the following key strokes to do a pass loss calibration:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNN
ACTIVE CH (set to [CH1]) RESPONSE THRU DONE:
ACTIVE CH (set to [CH2]) RESPONSE THRU DONE:
4Cal5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNN NNNNNNNNNNNNNNNNN
6. Perform the following key strokes to set up markers:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ACTIVE CH (set to [CH1]) MKR MODE MENU MARKERS: COUPLED
MARKERS: DESCRETE
4Marker5 ACTIVE CH (set to [CH2]) MKR MODE MENU MARKERS: DESCRETE
4Marker5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
7. Set the step attenuator to 10 dB.
8. Perform the following key strokes for a single sweep measurement:
4Trigger5
NNNNNNNNNNNNNNNNNNNN
SINGLE
9. Rotate RPG knob, and record the magnitude measurement reading value at 50.001 MHz and
the phase measurement reading value at 3 MHz on the calculation sheet.
10. Transcribe the test results to the performance test record.
11. Repeat the steps 8 and 10 for each step attenuator setting of 20 dB to 80 dB.
Performance Tests for E5100A/B Option 100/200/300/400/600 2-57