Download ELECTRICAL TROUBLESHOOTING MANUAL
Transcript
Calibration Procedures Precision Resolver Calibration Procedure (Cont) 2. Select the MOTORS OFF mode. 10.4.1 Calibrating Axis 1 3. Remove cover plate on the reference surface on gearbox 1. 4. Attach the synchronization fixture (ABB# 6896 0011-YM) to the flat surface and insert the corresponding measuring rod (6896 0011-YN) in one of the three holes in the base. 5. Use the Manual Brake Release Switch for Axis 1 and manually push the robot until the measuring rod is positioned within the flat surface on the calibration fixture’s elbow. WARNING! BE ESPECIALLY CAREFUL OPERATING THE ROBOT WHILE IN THE ROBOT WORKING AREA OR PERSONAL INJURY MAY OCCUR! 6. Align the pin and tool with a sliding caliper. Figure 1 - Aligning the Pin & Tool with a Sliding Caliper for Axis 1 Electrical Troubleshooting Guide IRB6400 M94A Page 10 - 15
Related documents
Axis 540plus Product manual
User's Guide
to read more about this robot
Graco PRECISIONSWIRL 310554V User's Manual
Manual de Uso
IDE11 Benutzerhandbuch V2.30
pericolo - Graco Inc.
Mises en garde
Télécharger
Autonomous control method and process for an investment casting
Accesorios
Conifer Rob 1.3 User Manual