Download Enterasys Enterasys SecureStack B2 B2G124-24 Specifications
Transcript
set lldp port med-trap
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables transmitting LLDP traps on ports fe.1.1 through fe.1.6.
B2(rw)->set lldp port trap enable fe.1.1-6
set lldp port med-trap
Use this command to enable or disable sending an LLDP‐MED notification when a change in the topology has been sensed on the port (that is, a remote endpoint device has been attached or removed from the port).
Syntax
set lldp port med-trap {enable | disable} port-string
Parameters
enable
Enables transmitting LLDP‐MED traps on the specified ports.
disable
Disables transmitting LLDP‐MED traps on the specified ports.
port‐string
Specifies the port or range of ports to be affected.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables transmitting LLDP‐MED traps on ports fe.1.1 through fe.1.6.
B2(rw)->set lldp port med-trap enable fe.1.1-6
set lldp port tx-tlv
Use this command to select the optional LLDP and LLDP‐MED TLVs to be transmitted in LLDPDUs by the specified port or ports. Use the show lldp port local‐info command to display the values of these TLVs for the port.
Syntax
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmtaddr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [medcap] [med-loc] [med-poe]} port-string
SecureStack B2 Configuration Guide
6-25
Related documents
Enterasys D-Series Specifications
Enterasys Networks 9034313
Enterasys C2K122-24 Specifications
Enterasys SecureStack A2 A2H124-48P Specifications
Enterasys Enterasys Matrix DFE-Gold Series Specifications
Enterasys Enterasys SecureStack B2 B2G124-24 Specifications
Enterasys 802.1Q Specifications
Enterasys 10GB-ER-SFPP network switch module
Enterasys N Standalone (NSA) Series Specifications
Enterasys N Standalone (NSA) Series Specifications
Enterasys C3G124-48P 48-Port Gigabit Ethernet Switch (C3G124-48P-G)
Release Notes Template