Download Enernet T9000 Setup guide

T9000 — MODEL 124 Operation Guide
Step 6
RUN BUTTON – Program / Manual Operation
If you started with the Morning time period, the next period, Day,
The RUN button toggles the thermostat between manual operating
will now be blinking. Follow steps two, three, four, and five above
mode and program operating mode. When in the program mode
for each period you wish to program.
your thermostat responds to the times and temperatures
programmed.
NAVIGATING
You can quickly step through to a specific item you want to change
Figure 6 shows a thermostat running in program mode. One of
by pressing the HEAT/COOL button until what you want to change
the four periods, in this case “Day”, is displayed, letting you know
is flashing. When the item you want to change is flashing, use the
which period of the day the program is in. When in manual mode
UP or DOWN button to adjust.
as shown in Figure 7, the period of the day is not displayed.
Instead, the word “Hold” will be displayed above the Set Point
EXITING PROGRAM MODE
temperature, indicating the thermostat is holding that temperature.
Pressing the PROGRAM button at anytime will exit out of the
programming mode, save your changes to memory and return you
In manual mode you can adjust to the desired temperature using
to normal thermostat operation.
the UP and DOWN buttons, and the thermostat will maintain that
temperature until you change it again.
11: 20 AM
HEAT
Th
Day
11: 20 AM
O
HEAT
Th
OFF
Set Point
Fan Auto
71 O
Hold
Set Point
Figure 6 – Program Mode Display
Fan Auto
70 O
Figure 7 – Manual Mode Display
© 2010 ENERNET Corporation • www.enernetcorp.com • 315-449-0839
Pub No. 12401-012210 / Page 8 of 16