Download User`s Manual

Transcript
CoPilot User’s Manual
IFR Operations
CoPilot has a number of features to facilitate IFR flight planning.
Multiple legs of a route may actually be a part of a single airway. The airway
designations are entered on the Edit Leg forms.
The flight plan route is summarized to eliminate waypoints that are
intermediate waypoints along an airway.
In addition to specifying a leg to be a part of an airway, legs can also be specified to be part of a SID
(Standard Instrument Departure), a STAR (Standard Terminal Arrival), or an Approach. All of these legs are
included in the route calculations (e.g. flight time and fuel consumption). Legs specified to be part of an
Airway, SID, or STAR are summarized on the flight plan route. Legs specified to be part of an Approach are
not included on the flight plan route.
A section of a route may be specified as a route to an alternate destination.
The alternate destination is entered into the flight plan.
The start of the route to the alternate destination is specified by entering a leg
with the From and To waypoints set to the primary destination. Any legs after
this leg are considered part of the route to the alternate destination.
In this example, the primary destination is CYTZ and the alternate
destination is CYYZ. Totals on the Route form are calculated to the primary
destination. Totals to the alternate destination can be seen by tapping on the
segment bar on the left side of the form.
The ETE on the Flight Plan form is the time to the primary destination. The
flight cost (see ”Cost Estimates” on page 20) is calculated to the primary
destination. The fuel reserve on the Weight & Balance form is for the
alternate destination.
16