Download Operator`s Manual

Figure C
Figure D
3. Easel Base
The easel base is the portion of the easel that immediately rests on the surface of the
table. This piece is made of 2” square aluminum tubing welded at all corners. Its dimensions are
24” x 24”. The table clamps are designed to securely clamp this component of the easel to the
table on which it rests. The extensions off the front of the base are the receptacles for the table
clamps and table clamp pins. In the center of this easel base can be found the electrical
enclosure. When viewed from the front, the left side of the base contains the plug for the
joystick. Resting on the top of this base is aluminum tracking on which the floating base slides
sit. The power supply wire extends through the rear of the base.
Figure E
Figure F
7