Download Clock Cable, 4601:5-104

Introduction
Introduction
NOTE: For the Eagle STP Software Release 30.0 IP7 8.0 all IPMX cards
must be replaced by High-speed Multiplexer (HMUX)(P/N 870-1965-04)
cards. All Maintenance Communications and Applications Processor
(MCAP) cards must be replaced by General Purpose Service Module-II
(GPSM-II) cards (P/N 870-2360-01) for Eagle software release 30.0 and
later. Beginning with EAGLE release 33.0, all IPMX cards must be
replaced by HMUX cards or High Speed IMT Packet Router (HIPR)
cards (P/N 870-2574-01).
NOTE: All Terminal Disk Modules (TDM) cards for Eagle software
release 30.0 or later must be P/N 870-0774-10 or later.
All Terminal Disk Modules-Global Timing Interface (TDM-GTI) cards
for Eagle software release 31.6 or later must be P/N 870-0774-15 or later.
These cards are installed at the factory by Tekelec Technical Support
and are not installed by customers of Tekelec.
NOTE: TDM-GTI is not available to systems that include DS0 cards.
The signal clocking for the DS0 card is provided by system clocks
derived from the Building Integrated Timing System (BITS) composite
clock signal. The Time Slot Counter (TSC) clock is shared with the clock
that is used for DS0 links. Customers with DS0 links can only use BITS
clocks as the TSC synchronization clock source.
Products of Tekelec’s Network Systems Division (NSD) include the EAGLE 5
Signaling Application System (SAS) Signaling Transfer Point (STP) and the
IP7 Secure Gateway (SG) system.
This Tekelec Signaling Products Installation-Eagle manual includes IP7
information and provides installation information for each system of the
following areas:
•
”General Installation Information”
•
”Frames and Shelves”
•
”Fuses and Alarm Panels”
•
”Eagle STP and IP7 Secure Gateway Assemblies”
•
”EOAP”
•
”LEDs”
•
”Connectors”
•
”Cables”
•
”Power Cords to Peripherals”
Refer to this manual to install components or the complete system.
Components that only apply to a specific system are clearly indicated.
1-6
910-4601-01 Revision D, May 2005