1
Download Clock Cable, 4601:5-104
Transcript
EOAP 4. Verify the status of the EOAP ports displayed in step 3.. An out-of-service EOAP port is shown by the entry OOS-MT-DSBLD in the PST field. This is an example of the possible output: rlghncxa03w 00-06-07 11:34:04 TRM PST SST 1 IS-NR Active 2 IS-NR Active 3 IS-NR Active 4 IS-NR Active 5 IS-NR Active 6 IS-NR Active 7 IS-NR Active 8 IS-NR Active 9 IS-NR Active 10 IS-NR Active 11 IS-NR Active 12 IS-NR Active 13 IS-NR Active 14 IS-NR Active 15 IS-NR Active 16 IS-NR Active Command Completed. EST Rel 26.0.0 AST ----------------------------------------------------------------- If either EOAP terminal is not out-of-service, go to step 5.. If both EOAP terminals are out-of-service, go to step 7.. 5. Take the terminal out of service using the rmv-trm command and specifying the ports. Enter these commands: rmv-trm:trm=4 rmv-trm:trm=10 After successful completion of each command, the system returns the following output: rlghncxa03w 00-06-07 00:57:31 EST Rel 26.0.0 Inhibit message sent to terminal rlghncxa03w 00-06-07 00:57:31 EST Rel 26.0.0 Command Completed. 6. Verify that the terminal that was placed out of service in step 5. is in the OOS-MT-DSBLD state by entering the rept-stat-trm command. This is an example of the possible output: 910-4601-01 Revision D, May 2005 6-121
