Download User's Guide - Allied Telesis
Transcript
Chapter 6: Configuring the Media Converter Line Cards Displaying the Parameter Settings of the AT-CM Line Cards Menus To view the current parameter settings of the AT-CM Line Cards from the menus: 1. From the Main Menu, select Module Status and Configuration to display the Module Status and Configuration menu shown in Figure 58 on page 158. 2. From the Module Status and Configuration menu, select the AT-CM Line Card you want to view. You can view only one line card at a time. The Module Configuration Menu in Figure 63 on page 169 is displayed. 3. Select Line Card Configuration to display the menu in Figure 72 on page 183. 4. Select Display Current Configuration. An example of the window is shown in Figure 61. Display Current Configuration Slot: 11 Module: AT-CM302 Operational Mode: Link Test + OAM Visible Mode Port A(100BaseFX) Port Enable: Enabled Negotiation: -Duplex: -Speed -MDI/MDIX: -Flow Control Enable Ingress Rate Limit: No Limit Egress Rate Limit: No Limit OAM Configuration Admin State: Mode: Maximum OAMPDU Size: Unidirectional Support: Loopback Support: Event Support: Variable Retrieval Support: Port B(100Base-TX) Enabled Manual negotiate Full 100 Base (100Base-TX) MDI Enable No Limit No Limit Enabled Active 64 Yes Yes Yes Yes Return to Line Card Configuration... Figure 61. Display Current Configuration Window 166
Related documents
Allied Telesis AT-CM301
Contax SW II - REV 4.01 User`s guide
User's Guide - Allied Telesis
Allied Telesis AT-CV5001DC
Allied Telesis AT-FS238a/2 User's Manual
Manual del Usuario
cantiere - vidaLaser
Allied Telesis Converteon™ one slot media chassis
RI850V4 Real-Time Operating System User`s Manual: Coding
CS-Manager User`s Manual
CentreCOM MC2601/MC2602 取扱説明書
CS-Manger Handbuch