Download Cabletron Systems Access Server 316 Installation guide
Transcript
User Authentication Configuration Problems Verify That Authentication Is Enabled Procedure To use the security user authentication system, you must enable authentication for each port. To display the user authentication settings for an interactive user port, use the following command. Substitute your port number for port 1: Local> SHOW PORT 1 Port 1: Test Server: GEMINI Character Size: 8 Flow Control: XON Parity: None Stop Bits: Dynamic Input Speed: 9600 Output Speed: 9600 Signal Control: Disabled Signal Select: CTS-DSR-RTS-DTR Access: Local Backwards Switch: None Break: Local Forwards Switch: None Default Protocol: LAT Autolink Timer One:10 Two:10 Local Switch: Name: Session Limit: Type: Ansi Default Menu: None Dialer Script: None ^^ PORT_1 8 Preferred Service: GALAXY Authorized Groups: 60, 70, 80 (Current) Groups: 60, 70, 80 Enabled Characteristics: Authentication, Autoconnect, Autoprompt, Broadcast, Failover, Input Flow Control, Lock, Loss Notification, Message Codes, Output Flow Control, Lock Notification, Verification If authentication is not enabled, enter the following command. Substitute your port number for port 2: Local> DEFINE PORT 2 AUTHENTICATION ENABLE 8-5