Download ManualV3 - Electromate

Transcript
Control Variables
Many motion applications include variable parameters. For example, a cut-to-length application
often requires that the cut length be variable. The motion process is the same, but the length is
changing. To accommodate these applications, advanced controllers provide symbolic
variables. A program can be written in which certain parameters, such as position or speed, are
defined as variables. The variables can later be assigned by the operator or determined by
program calculations. Variables allow the motion controller to perform certain mathematical
functions and to make decisions accordingly. This capability increases the performance of the
motion controller and allows it to perform some (background PLC) supervisory functions in
addition to the simple motion control.
A variable can be defined as a constant or can be equated to a controller parameter. For
example, the instruction:
V=3
sets the value of the variable V to 3. The instruction:
P = _TPX
reads the position of the X motor and equates the variable P to that value. Variables can be
defined in a variety of ways. For example, the instruction:
YERROR = _TEY
equates the variable YERROR to the position error of the Y motor.
Once the variable is defined, it can be used in mathematical operations. The controller can
perform mathematical functions which typically include algebraic, trigonometric, and logical
operations.
When the operation is completed, the controller can use the computation result to adjust the
system parameters. For example, the results can be used to change the speed, set the
distance, or change the filter gain. The use of variables is best illustrated by the following
example.
The following program shows an example where the X motor follows the position of the Y motor.
This is done by driving the X motor at a speed proportional to the position difference.
69
ELECTROMATE INDUSTRIAL SALES LTD.
TOLL FREE PHONE (877) SERVO98 • TOLL FREE FAX (877) SERVO99
[email protected] • WWW.ELECTROMATE.COM