Download ManualV3 - Electromate
Transcript
Because the average speed on this interval equals 15,000 counts/sec, the deceleration interval is 1500 counts. Accordingly, the coordinates of the points B1 and D1 are (4500,0) and (-4500,2000) respectively. To change the feedrate along the path, we break the segments AB and CD into two parts each and attach a vector speed to each segment by adding the symbol <n at the end of the segment instruction. This sets the attached speed to n counts/s. The resulting program is shown on the following page. Instruction Interpretation #MOVE VMXY VP 4500,0<20000 Label Specify XY plane Move to Point B1 at speed 20000 Move to Point B at speed 10000 Move to Point C - no speed change Move to Point D1 at speed 20000 Move to Point D at speed 10000 Move to Point E Move to Point A at speed 20000 End of path Vector acceleration Vector deceleration Start motion End of program VP 6000,0<10000 CR 1000,270,180 VP -4500, 2000<20000 VP -6000,2000<10000 CR 1000,90,180 VP 0,0<20000 VE VA 100000 VD 100000 BGS EN 163 ELECTROMATE INDUSTRIAL SALES LTD. TOLL FREE PHONE (877) SERVO98 • TOLL FREE FAX (877) SERVO99 [email protected] • WWW.ELECTROMATE.COM