Download Setting up and using - Agilent Technologies
Transcript
238 Chapter 10: Setting VPrep pipette task parameters VWorks User Guide Setting Dry Tips pipette task parameters About this topic This topic describes how to set the Dry Tips task parameters for a Velocity11 VPrep. Dry Tips pipette task defined The Dry Tips task is used with a tip dryer on a VPrep with a fixed-tip head to dry the pipette tips. There are two phases to drying: ❑ Initial Rapidly raises the temperature from ambient to a temperature suitable for drying. ❑ Final Maintains a suitable drying temperature. The goal when setting Dry Tips task parameters is to raise the temperature quickly for a short time and then apply less heat to dry the tips. Procedure To set Dry Tips task parameters: 1. Complete the following: Parameters Description Initial heat Percentage of the maximum heat. Initial heat time Time for which to apply the initial heat. Final heat Percentage of the maximum heat. Final heat time Time for which to apply the final heat, starting when the initial heat time ends. Related information For more information about... See... Creating a pipette process “Adding and configuring a pipette process task” on page 226 Creating protocol basics “Workflow for creating a protocol” on page 163 Setting pipette task parameters “Setting pipette task parameters” on page 173
Related documents
System and methods for sampling materials
BioCel User Guide, version 6.0
1046 Sci-Print MP2+ User Manual
njit-etd2002-027 - New Jersey Institute of Technology
HaloPlex Target Enrichment System
HaloPlex HS Target Enrichment System Automation Protocol For Ion
ATOM User Manual
This protocol - Pelkmans Lab
SureSelect Target Enrichment System for Illumina Paired
VCode User Guide
D-10H DN-20H
Microscan MS-4 User guide