Download Emulex Drivers for Windows

Transcript
Table 30: iSCSI Error Log Entries on Windows Server 2008 R2 (Continued)
Message ID
Severity
Message
Recommended Resolution
0x1a
Warning
WMI IOCTL error, code A.
The iSCSI driver failed a WMI IOCTL
request from the port driver because the
request was failed by the ARM firmware.
The event log entry includes the request
code in error.
An operation attempted from the Microsoft
WMI application resulted in an error. Check
the operation being attempted for errors.
0x1b
Warning
A configuration parameter is
out of range.
The iSCSI driver failed to load a
configuration value specified in the registry
because the value was out of range. The
driver uses the default value for this
configuration parameter.
The range specified for a configuration
parameter is either too large or too small,
and it must be corrected. Check the registry
configuration for new driver parameter
entries.
See “Driver Parameters for Windows” on
page 66 for the correct range of values
0x1d
Warning
A configuration parameter is
invalid.
The iSCSI driver ignored a configuration
entry because the entry was invalid.
Check the registry configuration for new
driver parameter entries. The invalid entry
must be removed or corrected.
See “Driver Parameters for Windows” on
page 66 for the correct range of values.
0x1e
Error
Failed to map Base Address
Register, failing driver load.
The iSCSI driver was unable to load
because it was unable to map one or more
PCI Base Address registers.
This failure may indicate a low memory
condition or a hardware error.
0x1f
Error
Hardware initialization has
failed - error code A.
The hardware initialization has failed. This
error causes the driver load to fail. The
error code included in the event log entry
identifies the specific point of failure.
This failure indicates that the hardware has
not been initialized or is malfunctioning.
This may also indicate that the firmware is
not running correctly.
Emulex Drivers for Windows User Manual
Page 114