Motorola MVME712AM Installation guide Download

Transcript
A
Configure and Environment Commands
Serial Port 2 Personality Artwork (PWA) Identifier
= "
Serial Port 2 Personality Module (PWA) Serial Number = "
IndustryPack A Board Identifier
= "
"
IndustryPack A (PWA) Serial Number
= "
"
IndustryPack A Artwork (PWA) Identifier = "
"
IndustryPack B Board Identifier
= "
"
IndustryPack B (PWA) Serial Number
= "
"
IndustryPack B Artwork (PWA) Identifier = "
"
IndustryPack C Board Identifier
= "
"
IndustryPack C (PWA) Serial Number
= "
"
IndustryPack C Artwork (PWA) Identifier = "
"
IndustryPack D Board Identifier
= "
"
IndustryPack D (PWA) Serial Number
= "
"
IndustryPack D Artwork (PWA) Identifier = "
"
162-Bug>
"
"
Note that the parameters that are quoted are left-justified character (ASCII)
strings padded with space characters, and the quotes (") are displayed to
indicate the size of the string. Parameters that are not quoted are considered
data strings, and data strings are right-justified. The data strings are padded
with zeroes if the length is not met.
In the event of corruption of the board information block, the command
displays a question mark "?" for nondisplayable characters. A warning
message (WARNING: Board Information Block Checksum Error) is also
displayed in the event of a checksum failure.
Using the I option initializes the unused area of the board information block
to zero.
Modification is permitted by using the M option of the command. At the end
of the modification session, you are prompted for the update to Non-Volatile
RAM (NVRAM). A Y response must be made for the update to occur; any other
response terminates the update (disregards all changes). The update also
recalculates the checksum.
Be cautious when modifying parameters. Some of these parameters are set up
by the factory, and correct board operation relies upon these parameters.
Once modification/update is complete, you can now display the current
contents as described earlier.
A-2
MVME162 Embedded Controller Installation Guide