1
Download Chapter 2 EXECUTIVE CONTROL COMMANDS
Transcript
POST User’s Reference Manual POST Module: Converts UAI/NASTRAN model information and analysis results to a form compatible with commercially available post-processors. DMAP Instruction Syntax: POST IN1,IN2,IN3,IN4,IN5 / OUT1,OUT2,OUT3,OUT4,OUT5,OUT6 // $ Arguments: Name Mode Argument Type Data Type INi INPUT TABLE N/A Table entity names. [1] At least one required OUTi OUTPUT TABLE N/AI New table entity names corresponding to INi. [2] At least one required Description Default Remarks: 1. The following table lists all entities which are processed by module POST. CSTM ECT EPT EQEXIN (HEAT) GEOM2 GEOM3 GEOM4 MPT OEF1 OEF1A OEF1NL OEF2 OES1 OES1A OES1AB OES1AL OES1ANL OES1B OES1L OES1NL OES2 OES2A OMES1B OMES1AB OMESH1 ONRGY1 ONRGY2 USET The following table lists all table entities known to be compatible with post-processor programs and therefore require no processing by module POST. All matrix entities are compatible and need not be processed. GEOM1 GPDT GPL LAMA OEFC1 OESC1 OESC1A OGPFB1 OPG1 OPG2 OPHIG OQG1 OQG2 OQMG1 OQMG2 OUGV1 OUGV2 Any input entities other than those shown above do not require processing, and are copied to the output entities unchanged. 2. The output entity names must begin with the same first four characters of the input entity name for the proper recognition of the data by some commercial post-processor programs. 3. To use this module, you must ALTER the Rigid Format after the input entities have been created by UAI/NASTRAN modules. 4. The OUTPUT2 module is normally used to write the output entities to a FORTRAN file. 5. If either of the entities of each pair INi and OUTi is purged, processing will continue on to the next pair. UAI/NASTRAN DIRECT MATRIX ABSTRACTION 8-83 8 DMAP
