Download Siemens SINUMERIK 802D sl Specifications

Transcript
Overview of alarms
06/2007
NCK alarms/ISO alarms
14310
Handwheel %1 configuration incorrect or inactive
Parameters:
%1 = Handwheel number
Definitions:
The inputs are using a drive with a drive number that does not exist or
an inactive drive for assignment of the handwheel (ENC_HANDWHEEL_MODULE_NR) or
an axis is using a measuring circuit which does not exist for the drive hardware.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Please inform the authorized personnel/service department. Check input configuration (machine data)
and/or drive hardware. Power-up is interrupted.
Program Continuation:
Switch control OFF - ON.
14320
Handwheel %1 used twice (%2) in channel %3 axis %4
Parameters:
%1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Definitions:
Warning that the designated handwheel has been used more than once:
The second parameter supplies the explanation:
1: Block with axial handwheel override for this axis cannot be performed for this axis because the
handwheel for the axis is performing a DRF motion
2: Block with speed override for the path cannot be performed because the handwheel for the axis of
the path is performing a DRF motion
3: Block with contour handwheel cannot be performed because the handwheel for the axis of the path
is performing a DRF motion
4: PLC axis with axial handwheel override cannot be started immediately because the handwheel for
the axis is performing a DRF motion
5: The axis is a reciprocating axis with axial handwheel override, the oscillating motion cannot be
started immediately because the handwheel for the axis is performing a DRF motion
6: The DRF motion for this axis cannot be performed because an handwheel override for this axis with
the handwheel is active
7: The DRF motion for this axis cannot be performed because a speed override of the path with the
handwheel is active and the axis belongs to the path
8: The DRF motion for this axis cannot be performed because the contour handwheel with this handwheel is active and the axis belongs to the path
9: The DRF motion for this axis cannot be performed because the axis is a PLC axis with handwheel
override that is active with the handwheel
10: The DRF motion for this axis cannot be performed because the axis as reciprocating axis with
handwheel override is active with this handwheel
Reaction:
Alarm display.
Remedy:
Use the handwheel for only one purpose.
Program Continuation:
Alarm display showing cause of alarm disappears. No further operator action necessary.
14400
Channel %1 block %2 tool radius compensation active at transformation
switchover
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
A change of transformation is not allowed when tool radius compensation is active.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Perform tool radius compensation in the NC part program with G40 (in a block with G00 or G01) before
performing a transformation change.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
2-134
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition