Download Siemens SINUMERIK 802D sl Specifications

Transcript
06/2007
Overview of alarms
NCK alarms/ISO alarms
Program Continuation:
4300
Switch control OFF - ON.
Declaration in MD %1 is not allowed for axis %2.
Parameters:
%1 = string: MD identifier
%2 = axis name, spindle number
Definitions:
Geometry axes and spindles cannot be operated as concurrent positioning axes.
Reaction:
Alarm display.
Remedy:
Please inform the authorized personnel/service department. Reset MD 30450
IS_CONCURRENT_POS_AX for the axis concerned.
Program Continuation:
Clear alarm with the RESET key. Restart part program
4310
Declaration in MD %1 index %2 is not allowed.
Parameters:
%1 = string: MD identifier
%2 = index in MD array
Definitions:
The MD values must be written in the array in ascending order.
Reaction:
Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Correct the MD
Program Continuation:
Teileprogramm neu starten.Clear alarm with the RESET key in all channels of this mode group.
Restart part program.
4320
Axis %1 function %2 %3 and %4 not allowed
Parameters:
%1 = string: Axis identifier
%2 = string: MD identifier
%3 = string: Bit
%4 = string: MD identifier
Definitions:
The functions declared by the machine data specified cannot be activated at the same time for one
axis.
Reaction:
Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Deactivate one of the functions.
Program Continuation:
Switch control OFF - ON.
4340
Channel %1 block %2 invalid transformation type in transformation no.
%3
Parameters:
%1 = channel number
%2 = transformation number
Definitions:
An invalid, i.e. undefined, number was entered in one of the machine data 24100 TRAFO_TYPE_1.
This alarm occurs only if a certain type of transformation is not possible in the specified control type.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Valid transformation type entered
Program Continuation:
Clear alarm with the RESET key. Restart part program
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition
2-33