Download Siemens SINUMERIK 802D sl Specifications

Transcript
Overview of alarms
06/2007
Cycle alarms
61265
Channel %1 block %2: Too many restrictions, use rectangular pocket
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling a maximum of only 3 sides can be delimited.
Alarm triggered by following cycle: CYCLE61
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Use pocket cycle.
Program Continuation:
Clear alarm with the RESET key. Restart part program
61266
Channel %1 Block %2: Illegal machining direction
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the delimitations and the direction of machining do not match.
Alarm triggered by following cycle: CYCLE61
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select another direction of machining.
Program Continuation:
Clear alarm with the RESET key. Restart part program
61267
Channel %1 Block %2: Plane infeed too large, residual corners remain
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the plane infeed must not exceed 85%.
Alarm triggered by following cycle: CYCLE61
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a smaller plane infeed, as otherwise residual corners will be left over.
Program Continuation:
Clear alarm with the RESET key. Restart part program
61268
Channel %1 block %2: Illegal machining direction, residual corners are
left over.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In face milling, the machining direction does not match the selected delimitations.
Alarm triggered by following cycle: CYCLE61.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
The machining direction must be selected to match the delimitations.
Program Continuation:
Clear alarm with the RESET key. Restart part program
2-300
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition