Siemens C10 User guide Download

Transcript
HWC_AppendixA.fm
Controller, Access Points and Convergence Software system states and LEDs
Wireless AP system states
State / Process Description
LEDs
Registration
Wireless AP learns the HiPath Wireless Controller's IP
address, and can begin the Registration process
Orange (blink)
Failed
Registration
Wireless AP fails to learn the HiPath Wireless Controller's Red (blink)
IP address.
Standby
1. Wireless AP enters this state from "Discovery" when it
encounters an active HiPath Wireless Controller and
completes the Registration process.
2. Wireless AP enters this state from "Active" when it
receives a control message from the HiPath Wireless
Controller to enter this state. If the Wireless AP has any
wireless device traffic, it will drop the traffic.
Green (blink)
Wireless AP fails to register. It will wait 5 seconds and try
again.
Red (slow
blink)
Firmware download from the HiPath Wireless Controller is Orange +
in progress
green (blink)
Active (Ready)
Table A-1
Wireless AP has received a control message from an active Green (steady)
HiPath Wireless Controller to enter "active" or "ready" state.
It is ready to receive wireless traffic.
Note: The two Traffic LEDs on either side of the Status LED
display a green (blink) if there is active wireless traffic. The
left LED is for the 2.4 GHz radio. The right LED is for the 5
GHz radio.
Wireless AP system states and status LED displays
A31003-W1010-A100-1-7619, July 2005
HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide
179