Download Siemens C10 User guide

Transcript
HWC_AppendixB.fm
CLI command reference
Category
OSPF
Syntax
Comment
<hostname>:ip#
show routes
displays a numbered
table of static routes
<hostname>:ip#
no route #n
clears static route #n
OR
no route <x.y.z.a>
clears static route; has to
match an existing route
with address x.y.z.a
<hostname>#
ip
<hostname>:ip#
(no) protocol ospf
<hostname>:ip#
ospf
<hostname>:ospf#
routerid <value>
only 1 protocol can be
enabled on the AC
area <area-id>
areatype
<default|stub|nssa>
config ospfinterface
<0|1|2|3>
<hostname>:ospf.0#
(no) ospfinterface
Port has to be made
router port during esa
configuration
linkcost <val|default>
auth <on|off>
authkey <password>
hello <val|default>
dead <val|default>
retx <val|default>
txdelay <val|default>
IP Addresses
Management <hostname>#
Port
Table B-1
182
interface
<hostname>:interface:# eth0
selects interface to
configure
<hostname>:interface:
eth0#
hostname
hostname '<string>'
CLI commands
A31003-W1010-A100-1-7619, July 2005
HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide