Siemens C10 User guide Download

Controller, Access Points and Convergence Software configuration
Filtering at the interface level
Exception filtering rules that you will define for a VNS will apply to the wireless device users
after their authentication, whereas the filtering rules that you define here apply to all traffic on
a physical port.
Define port exception filters
Click on the HiPath Wireless Controller tab. Click on the Port Exception Filters option.
The Port Exception Filters screen appears.
Select the data port from the pull-down list to which these filters will apply.
For each filtering rule you are defining:
IP / Port:
Type in the destination IP address. You can also specify an IP range, a port
designation or a port range on that IP address.
Default is N/A. To specify a protocol, select from the drop-down list (may
include UDP, TCP, IPsec-ESP, IPsec-AH, ICMP).
Click on the Add button. The information appears in a new line in the Filter area of the
Highlight the new filtering rule and click Allow checkbox on to allow traffic. Leave
unchecked to disallow traffic.
Edit the order of a filtering rule by highlighting the line and clicking on the Up and Down
buttons. The filtering rules are executed in the order defined here.
To save the filtering rules, click on the Save button.
A31003-W1010-A100-1-7619, July 2005
HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide