Agilent Technologies 2000 X-Series Technical data Download

Transcript
Obsolete and Discontinued Commands
33
:MEASure:UPPer
(see page 790)
Command Syntax
:MEASure:UPPer <value>
The :MEASure:UPPer command sets the upper measurement threshold
value. This value and the LOWer value represent absolute values when the
thresholds are ABSolute and percentage when the thresholds are PERCent
as defined by the :MEASure:DEFine THResholds command.
NOTE
Query Syntax
The :MEASure:UPPer command is obsolete and is provided for backward compatibility to
previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see page 344)
instead.
:MEASure:UPPer?
The :MEASure:UPPer? query returns the current upper threshold level.
Return Format
<value><NL>
<value> ::= the user-defined upper threshold in NR3 format
See Also
• "Introduction to :MEASure Commands" on page 340
• ":MEASure:LOWer" on page 725
• ":MEASure:THResholds" on page 728
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
733