Download TP 277, OP 277 (WinCC flexible) - Service, Support

Transcript
Operating a Project
8.10 Operating Status Force
Ruler
When configured, a ruler is available to provide an exact reading of the trend values in the
value table.
You can move the ruler to the desired position of the Trend view.
Operation
The trend view can be operated as follows:
• Enlarge or reduce the display of time intervals
• Scroll forward or back by one display width
• Stop or continue the trend recording.
• Move the ruler
• Hide and display the ruler
The configuration engineer can configure function keys or operator controls used to operate
the Trend view.
Further information on this may be available in your plant documentation.
8.10
8.10.1
8.10
Operating Status Force
Overview
Application
You read or write access values of the connected controller directly with status force. Status
force allows you to monitor or change operations of the controller program, etc. You don't
need to connect an additional programming device or additional PC to the controller.
Note
Status force can only be used in combination with SIMATIC S5 or SIMATIC S7.
TP 277, OP 277 (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DH01-0AB0
8-25