MP 277 - Service, Support Download

Configuring the device
6.7 Setting the Delay Time
1. Change to the "Memory" tab.
The memory information is displayed.
Size of data storage space
Size of program storage space
The blue area shows the size of the available memory.
2. If you want to change the size of the assigned storage space, mode the slider.
The change is displayed under "Allocated". The slider sets the ratio between data and
program storage space.
3. Close the dialog.
Setting the Delay Time
The project is opened following a delay time when the HMI device is switched on. The
Loader is displayed during the delay time. Read the description of the "Start" button in the
section "Loader (Page 69)" when doing this.
Do not use the delay time to implement a temporary access protection.
MP 277
Operating Instructions, 07/2014, A5E02479740-02