MP 277 - Service, Support Download

Installing and connecting the device
4.3 Connecting the HMI device
Connecting a Printer.
Configuration graphic
The following figure shows the connection of the HMI device and the printer.
Note when connecting
Use only cables with metal-braided shielding grounded at both ends to connect the HMI
device and printer.
Use a cross-cable for the Ethernet connection when using a point-to-point connection.
Some printers may require the ASCII character set used in the project to also be defined on
the printer.
You can find the list of current printers and required settings for HMI devices on the Internet
Read the documentation supplied with the printer when connecting it.
See also
Ports (Page 45)
Connecting a USB device (Page 55)
MP 277
Operating Instructions, 07/2014, A5E02479740-02