MP 277 - Service, Support Download

Transcript
Commissioning a project
7.5 Transfer project to the HMI device
7.5.2.3
Starting automatic transfer
Introduction
The HMI device can be automatically switched to "Transfer" mode during runtime as soon as
transfer is started on the configuring PC connected.
Automatic transfer is particularly suited for the test phase of a new project since transfer is
completed without interfering with the HMI device.
Automatic transfer is available for the following data channels:
● Serial
● MPI/PROFIBUS DP
● USB
● Ethernet
Note
If the automatic transfer has been activated on the HMI device and a transfer is initiated
on the configuring PC, the project currently running is automatically stopped. The HMI
device then automatically switches to "Transfer" mode.
After the commissioning phase, deactivate the automatic transfer so that the HMI device
cannot be inadvertently switched to transfer mode. The transfer mode can trigger
unintentional actions in the device.
You can set a password for the Loader of the HMI device to restrict access to the transfer
settings and thus avoid unauthorized modifications.
Requirements
● The project *.hmi is opened in WinCC flexible.
● The HMI device is connected to a configuring PC
● The data channel is configured on the HMI device
● The automatic transfer is activated in the data channel for the transfer.
● The project is started on the HMI device.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
143