MP 277 - Service, Support Download

Transcript
Configuring the device
6.4 Changing settings for operation
6.4.2
Setting the Character Repetition of the Keyboard
You can set the character repeat for the keyboard or screen keyboard in the Control Panel.
Requirement
You have opened the "Keyboard Properties" dialog box with the "Keyboard" icon.
①
②
③
④
Check box for activating the character repeat
Slider control and buttons for the delay time before character repeat
Slider control and buttons for the rate of the character repeat
Test field
Procedure
1. Select the "Enable character repeat" check box to enable the character repeat.
2. Use the buttons to set the delay and rate of the character repeat. You can also use the
slider control for this.
3. Verify your settings.
For HMI devices with touch operation.
– Touch the test field. The screen keyboard opens.
– Move the screen keyboard as needed.
– Touch any character and keep it pressed.
– Check the implementation of the character repetition and the rate of the character
repetition in the test field.
– Correct your setting if necessary.
For HMI devices with key operation.
– Select the test field.
– Press an alphanumeric key and keep the key pressed down.
– Check the implementation of the character repetition and the rate of the character
repetition in the test field.
– Correct your setting if necessary.
4. Confirm your entries.
The dialog box closes.
The character repeat for the keyboard is now set.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
85