MP 277 - Service, Support Download

Transcript
Installing and connecting the device
4.2 Mounting the HMI Device
Proceed as follows:
1. Check that the mounting seal is fitted on the HMI device.
Do not install the mounting seal turned inside out. This may cause leaks in the mounting
cut-out.
2. Insert the HMI device into the mounting cutout from the front.
3. Insert a mounting clip into a recess on the HMI device.
4. Fasten the mounting clip as described in the enclosed product information. The product
information on spring mounting clips or aluminum mounting clips is available on the
Internet at the following link:
– Product Information "Spring clamp"
(http://support.automation.siemens.com/WW/view/en/34916893)
– Product Information "Metal mounting clamps"
(http://support.automation.siemens.com/WW/view/en/34915725)
5. Repeat steps 3 and 4 for all mounting clips that are required for the installation of the HMI
device.
Note
Check the fit of the mounting seal on the front. The mounting seal must not protrude from
the HMI device.
Otherwise, repeat steps 1 to 5.
Positions of mounting clips on the MP 277 8" Touch
You will need 10 mounting clips in total. The following figure shows the positions of the
mounting clips.
MP 277
42
Operating Instructions, 07/2014, A5E02479740-02