MP 277 - Service, Support Download

Transcript
Planning application
3.2 Mounting positions
3.2
Mounting positions
Mounting position
The HMI device is suitable for installation in:
● Mounting cabinets
● Control cabinets
● Switchboards
● Consoles
In the following, all of these mounting options are referred to by the general term "cabinet".
The HMI device is self-ventilated and approved for vertical and inclined mounting in
stationary cabinets.
①
②
Mounting position
Deviation from the vertical
Inclined
≤ 35°
Vertical
0°
NOTICE
Damage due to overheating
Convection through the HMI device is reduced with installation at an angle.This fact also
reduces the maximum permitted operating temperature for operation.
With sufficient forced ventilation, you can operate the HMI device at an inclined mounting
position up to the permitted ambient temperature for vertical installation.
Otherwise the HMI device may be damaged and the approvals and warranty may become
obsolete.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
37